![]() He tried the ammo in the barrel and ended up throating it a little then shipped it out. I told Dan how long I wanted to load my reloads (based on Coltgov's info) and it turns out he found some dummy loads in the shop that a previous customer sent him that was close to the bullet profile/ OAL I wanted to use. Dan from LWD recommended that I do this for my 9mm major project. Have them test the rounds in the barrel to make sure they fit, if not, they can throat the barrel for you. You can load some dummy rounds up and send them to LWD. I load to a length of 1.135-40 right now. I want a fully supported chamber, but I don’t want to be fiddlefarting around with shorter cartridge OAL and making them fit the chamber. So if reports turn out that the slides are reliable and equal to OEM maybe a better setup would be a LWD slide and a KKM barrel. ![]() ![]() ![]() I haven't compared support between Lone Wolf and a stock barrel, but I can tell you the chambers on Lone Wolf barrels tend to run extremely tight. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |